1. Replace the lubricating oil in the worm gear reducer of the carton packaging machine. The lubricating oil can be selected from No. 10, No. 20 or No. 30 oil.
2. After each component is repaired, assemble the whole machine, start it up, and observe whether the machine is running normally. Appropriately heat the drum, and put in a small amount of special oil for carton packaging machinery to melt and cover the inner surface of the cylinder, and then cut off all power. If necessary, spray paint on the exterior of the machine, cover it with plastic paper after drying, and store it in a dry place.
3. If the chain is too loose, it can be adjusted by removing several sections first. If it is seriously elongated, it should be replaced. When using the carton machine, it should be used in a certain way and principle, and maintenance and maintenance should be carried out in a certain way, and different faults should be solved in time. When adjusting and replacing the chain, attention should be paid: the installation direction of the spring card at the chain joint should be the same as that of the chain joint. The running direction of the chain is the same, so as to avoid impact, jump, or even fall off during running.
4. Disassemble and wash all rolling bearings, and add new grease. Calcium-sodium-based grease can be used.
5. Remove the dirt on all friction surfaces, especially the chain and sprocket, and refill the lubricating oil. The maintenance and repair of carton packaging machinery requires certain technical personnel to maintain and repair to ensure the quality and performance of carton packaging machinery in use, and play an important role and value in the production of carton boxes.
6. Check the stove for smoke leakage. If smoke leakage is found, check the drum smoke blocking ring, stove and chimney, etc. If any damage is found, repair and replace it in time. For electric heating models, check whether the electric heating tube is damaged, and replace the damaged ones.